|
|
||
|
|
|
|
|
|
Know nodes |
|
|
Clinch simple and double for girella
The double Clinch is a variant of improved Clinch simple, one of the
knots in girelle most commonly used today. It differs from the
latter only for the fact that the line passing through the eye of
girella 2 times instead of only 1. The Clinch twice as likely to be
preferred by line by line while for large node is cleaner and less
bulky with Clinch simple. threads his head in girella free, and then
you threads again, to form a double buttonhole that there must be
close (only once for Clinch simple). |
||
|
1) threads his head in girella free, and then you threads again, to form a double buttonhole that there must be close (1 only once for Clinch simple). |
||
|
|
||
|
2) It envelops his head free spiral around the carrier for at least 3 times, back, and then threads the head free in both eyelets formed at the beginning. |
||
|
|
||
|
3)
For
the closure of the node keep the girella, wetting the line and
the first and pull the bearing, then the head free and then
again the bearing so that the node is very tight and filante
then cut the line surplus. |
||
|
|
||
|
Clinch simple (shock leader) Surely the most reliable and used node for shock leaders, however, does not allow combinations of lines with differences of greater than 0.25. Although its construction seems difficult in reality they are two simple knots Clinch conflict. |
||
|
1) Align the two lines to match and block with the fingers of the hand Left. |
||
|
|
||
|
2) The line of shockleader "A" must do 3 spirals on the line "B" and then the end will be inserted inside dell'asola "X" that has failed to create outwards. |
||
|
|
||
|
3) Change your fingers locking. The line "B" will have to do
3 spirals on the line "A" and then the end will be inserted
nell'asola "Y" that has failed to create inwards. |
||
|
|
||
|
4) Make the end "B" upward and cut two lines the same length of about 5 cm. Wet the lines, blocking the teeth with the two ends that you cut and pull with the decision lines mothers "A" and "B". |
||
|
|
||
|
5) Cut to 1 mm the lines A and B that left opposed. Make sure the node is well executed as will have to pass between the rings, cane and should give the least possible friction, if not cut and redo the operation. |
||
|
|
||
|
more >> |
||
|
|
||
|
All right reserved - webmaster Santo Acciaro |
||
