|
|
|||
|
|
|
||
|
|
Know nodes |
||
|
Node eight This node, although not possessing exceptional characteristics, is to appreciate the speed and simplicity of implementation as well as for good grip due straining always to tighten. It can be used only with hooks dall'anello bent inwards or outwards. The hooks of this kind are often not paid, so we need to check the point where the ring closes as if the two parties are not perfectly put together, the nylon could go to counter the sharp edge of the metal with break increasing traction. |
|||
|
1) It begins by introducing the wire in the ring sliding for about ten centimeters, then, holding the sleeping approached to stem in the hook, with the current form a ring passing on the opposite side of the stem through to ninety degrees. |
|||
|
|
|||
|
2) With the power back the body of line wrapping and forming a second ring, which closes the crossing point where the wires were previously cross. |
|||
|
|
|||
|
3) It should go free inside the head of the first ring so that the current is out parallel to stem of the hook. |
|||
|
|
|||
|
4) It lubricates, pulling his head free and the body of line and are tighten the rings around the stem hook giving rise to cross two turns. When the node is very tight so you scroll to counter the metal ring and ends by cutting his head open to a millimeter from the node.
|
|||
|
|
|||
|
Node Crowford |
|||
|
The node of Crowford still calls into question the figure to eight this time performed on him to the body of lence on top of ring metal. Node quick and easy is able to keep up to ninety-five percent of breaking load of line used. with any useful tool, hook, girella or artificial, which is equipped with eyelet. |
|||
|
1) It introduces in the ring the head free for about fifteen centimeters. You go back and with the power wraps the sleeping with a blows while keeping in place the ring and wire. |
|||
|
|
|||
|
2) Continue wire resulting in a second blows to climb supplementing the figure of eight. |
|||
|
|
|||
|
3)
You go
free in the head or highest of eight after circumvented, so that
the head free bait parallel to the body line |
|||
|
|
|||
|
4)
We will now proceed to lubrication and acts on the head free
until the two coils are not well closed around the body line and
then you slide against the ring node forcefully pulling the body
of line. Finally cut his head free two millimeters from the node |
|||
|
|
|||
| << back |
more >> |
||
|
|
|||
|
All right reserved - webmaster Santo Acciaro |
|||
